1. Home
  2. Guides
  3. Keeping speakers on time

Guide

How to keep speakers on time

Speakers rarely run over on purpose. They run over because nobody showed them the clock. A practical system for before, during and after each talk.

Updated By The runofsho team5 min read
SHORT ANSWER

Tell every speaker their exact length and what the signals mean before they go on. Put a countdown timer where they can see it from the lectern, turn it amber with about two minutes left and red at about thirty seconds, and send a short on-screen message if they keep going. Hold your slack in Q&A and breaks so one long talk does not push the whole day.

ON THIS PAGE
  1. Why talks run over
  2. Before the event: the brief
  3. Check the length before show day
  4. On stage: the countdown
  5. Wrap-up thresholds
  6. Messages: the polite interruption
  7. When a speaker keeps going
  8. Protect the schedule, not just the talk
  9. Panels and fireside chats
  10. FAQ

Why talks run over

Three reasons cover most cases:

  • The speaker was told a slot ("you're on at 10:30") but not a length.
  • The speaker wrote more than fits. People overestimate how fast they talk in front of a room.
  • The speaker cannot see a clock, or can see one that only counts up.

Each has a fix, and none of them involves walking on stage.

Before the event: the brief

Send one short message to every speaker a week out, and repeat it in the green room:

  1. Your length, not your slot. "You have 18 minutes of talk and 5 of Q&A."
  2. Where the timer is. "There is a countdown on the floor monitor, front and center."
  3. What the colors mean. "Amber means two minutes. Red means thirty seconds. At zero it counts up in red."
  4. What happens at zero. "The host will walk on at plus one minute."

The fourth line does the most work. Speakers finish on time when they know there is a real, polite, pre-agreed end.

Check the length before show day

Ask for the script or the slide deck and do the arithmetic. Planning figures vary by source, so use a range. Conversational American English averages about 150 words a minute, a figure widely attributed to the National Center for Voice and Speech, while VirtualSpeech measured a median of 116 words a minute across conference and event talks in its 2026 data set of 32,809 practice presentations.

Talk length Words at 115 wpm (measured median) Words at 130 wpm (comfortable) Words at 150 wpm (conversational)
5 minutes 575 650 750
10 minutes 1,150 1,300 1,500
18 minutes 2,070 2,340 2,700
20 minutes 2,300 2,600 3,000
30 minutes 3,450 3,900 4,500
45 minutes 5,175 5,850 6,750

If a speaker sends 4,000 words for a 20-minute slot, you know today, not at minute 19. The speech length calculator converts any word count.

On stage: the countdown

Put the timer where the speaker looks naturally: a confidence monitor at the foot of the stage, or a screen at the back of the room in their eyeline. A phone on the lectern gets covered by notes.

What the display should show:

  • Time remaining, large. Counting down, not up.
  • A color state. People notice a color change in peripheral vision long before they read digits.
  • Overtime. At zero, keep counting, in red, with a plus sign. A timer that stops at 0:00 tells the speaker nothing about how late they are.

Wrap-up thresholds

Set the color changes relative to the length of the talk. These are sensible starting points, not rules. Adjust them to the speaker.

Talk length Amber at Red at Notes
Up to 5 minutes 1:00 left 0:15 left Lightning talks need short warnings.
10 to 20 minutes 2:00 left 0:30 left The common default.
30 to 45 minutes 5:00 left 1:00 left Gives time to land a conclusion.
60 minutes or more 10:00 left 2:00 left Add a message at the halfway point.

In runofsho each item carries its own thresholds, so a five-minute sponsor slot and a forty-minute keynote in the same rundown warn at different points.

Messages: the polite interruption

When color is not enough, put words on the screen. Keep them to four words or fewer so they can be read in a glance:

  • "Please wrap up"
  • "2 minutes"
  • "Skip to Q&A"
  • "Repeat the question"
  • "Slow down"

Flash the message once to draw the eye, then leave it up. Clear it when the speaker responds, so the next message means something.

When a speaker keeps going

Agree the escalation with the producer before doors, so nobody has to improvise authority in the moment.

Overtime Action Who
0:00 Timer turns red and counts up Automatic
+0:30 Message: "Please wrap up" Show caller
+1:00 Host moves to the edge of the stage, in view Stage manager
+2:00 Walk-on music under, host enters and thanks the speaker Show caller, audio, host
+3:00 Lectern microphone fades as the host takes over Producer's decision only

Most talks end at the second line. The value of the table is that everyone knows there is a third.

Protect the schedule, not just the talk

  • Keep slack in Q&A and breaks. A ten-minute Q&A can become five without anyone being cut off mid-sentence.
  • Watch the total, not only the talk. A speaker who is two minutes over when the day is four minutes under needs no action at all. That is what the over/under figure is for. See back-timing and hard outs.
  • Tell the next speaker. If you shorten their slot, they should hear it from the stage manager before they walk on, not discover it from the clock.

Panels and fireside chats

A panel has no script to count. Brief the moderator instead of the panelists: give them the countdown, the number of questions that fit, and a closing question to use when the timer turns amber. Send messages to the moderator by name.

FAQ

What is the best way to signal time to a speaker?

A large countdown they can see from where they stand, with a color change at two minutes and at thirty seconds. It is silent, the audience cannot see it, and it does not rely on the speaker noticing a person waving.

How long before the end should the warning appear?

For a typical 10 to 20 minute talk, turn amber at two minutes and red at thirty seconds. Use shorter warnings for lightning talks and longer ones for keynotes.

What is a confidence monitor?

A screen facing the stage that only the presenter sees. It usually shows their slides or notes and a countdown timer, so they do not need to turn around or look at a watch.

How do you cut off a speaker politely?

Follow the steps you agreed in advance: an on-screen message, then the host visibly waiting, then music and the host walking on to thank them. Thanking a speaker by name is the kindest way to end a talk.

How many words is a 20-minute talk?

About 2,300 to 3,000, depending on pace. At a comfortable 130 words a minute it is 2,600 words.

See it run before your next show.

Open the sample room, start a cue, add a minute and send a message. No account needed.

Try a sample room